To achieve the maximum benefit from a specialized chemical like the Desulfurization Defoamer MT4060, proper application is key. Understanding the recommended methods and considerations ensures optimal performance, efficiency, and cost-effectiveness in industrial processes. NINGBO INNO PHARMCHEM CO., LTD. provides comprehensive guidance to help clients leverage our advanced chemical solutions.

The primary goal of a desulfurization defoamer is to quickly and effectively eliminate foam and prevent its recurrence within the wet desulfurization system. The addition method is crucial for achieving this. For rapid foam elimination, it is recommended to add the defoamer to the pit of the process supplemental water. This ensures that the defoamer is introduced directly into the circulating slurry where foaming is most problematic.

When it comes to the method of dosing, flexibility is important to accommodate various operational setups. Based on on-site equipment conditions and process flow, users can opt for either intermittent dosing or continuous dosing using a metering pump. Continuous dosing is generally preferred for maintaining a consistent level of foam control throughout the operational cycle, ensuring that foam is managed proactively rather than reactively. Intermittent dosing can be effective for addressing specific foaming events or as a shock treatment when initial foaming is severe.

Determining the correct dosage is a critical factor influenced by several variables. The composition of the substance causing foaming, the volume of flue gas being treated, the quality and type of coal used, the combustion process, and the nature and concentration of the absorbent all play a role. Therefore, while general guidelines exist, the exact dosage should be determined based on specific site conditions and experimentation. Typically, when foaming overflow is observed in the absorption tower, an initial 'impact dose' of approximately 0.5-1.0 kg of the reagent can be applied. Following this initial application, the dosage should be adjusted based on the observed on-site situation and the sustained effectiveness of the defoamer.

It is important to note that while dilution might seem like a way to extend product use, it is generally not recommended for our MT4060 defoamer as it can diminish its effectiveness and spread rate. For best results, use the product as supplied. NINGBO INNO PHARMCHEM CO., LTD. offers technical support to help clients fine-tune their application strategies, ensuring they achieve the desired foam control and operational efficiency from our desulfurization defoamer. Proper application is the bridge between a high-quality product and successful industrial performance.